Furnace Repair in Colorado Springs
Need heating repair in Colorado Springs? CoMech diagnoses gas-furnace ignition, airflow and thermostat problems, explains your repair options and checks operation after the work.
Complete service for the problem in front of you
Flame shutting off after ignition
CoMech responded to a no-heat call at a Colorado Springs home. During testing, the furnace flame came on for about two seconds, then went out.
Our technician removed, cleaned and reinstalled the existing flame sensor, then checked operation again. The service record confirms the furnace was working properly after the repair.
From a CoMech customer project
A residential furnace installation from CoMech's customer job photos.
Heating equipment involves fuel, combustion and electrical components. Our technicians evaluate performance and safety before recommending the next step.
Schedule Colorado Springs service
Serving Colorado Springs and communities throughout El Paso County. See the areas we serve or call to confirm service at your address.
Call during office hours or reach us for available after-hours support.
Call CoMechFurnace repair, a tune-up or replacement?
Our heating service covers all of El Paso County, from Colorado Springs neighborhoods to the county’s towns and unincorporated communities. Check local service coverage and call with your address and furnace symptoms to confirm scheduling.
If your furnace will not heat, shuts off repeatedly or has a new operating problem, start with diagnosis. A tune-up is preventive care; it does not replace troubleshooting an active breakdown.
A repair decision should consider the fault, repair cost, equipment condition and history of failures. Age alone does not tell you whether replacement is the right choice.
Replacement prices are preliminary budgets. You can explore them without entering contact details, then decide whether to request an evaluation.
Frequently asked questions
What should I check before calling for furnace repair?
Confirm the thermostat is set to heat, the filter is not severely restricted and the furnace switch and breaker are on. Do not repeatedly reset equipment or continue operating it if you smell gas or suspect a combustion problem.
Why does my furnace turn on and off repeatedly?
Short cycling can result from airflow restriction, thermostat issues, safety-limit operation, ignition problems or equipment sizing. Diagnosis should identify the cause instead of bypassing a safety control.
Can CoMech help with an after-hours heating problem?
After-hours service is available based on technician availability. Call 719-205-0437 for the quickest response.